Know your RPM

I was asked to oversee the installation of a hydraulic winch system installed on a workboat and designed by (winch experts)
My client had used this company before and was very satisfied with their expertise and service. If my client was happy then so was I.
It came the day when I had to inspect the installation. There was a gear pump attached to a large diesel engine via a flexible coupling, the winch was fitted on deck and the control valve, counterbalance valve with manifold were supplied loose.
I studied the circuit and the first thing that caught my attention was the closed centre control valve. This prompted an immediate phone call to the designer, the last thing we wanted was a hot system. He assured me that the control valve supplied was in fact a Pressure to Tank configuration and that he had drawn the symbol incorrectly. I then asked him what speed had he designed the pump to run at, “1000rpm” he said.
Now under normal conditions whilst using the winch the engine speed would run at 1000rpm but when the boat steamed from one position to another the engine rpm can increase to 2100-2200rpm, more than twice the design speed and what is more important twice the design flow.
Now we have a problem!
The control valve and pipe-work was not large enough to handle this extra flow. The first suggestion by the designer was to increase the size of the control valve, an obvious solution you might think. The first problem was that it would need larger diameter hoses (difficult to get onto the valve) but more importantly the valve looses its sensitivity due to the flow gain of the larger valve. Being a proportional valve and using a joystick with electrical control the winch would not have the sensitivity and less easy to control at low speed.
The better option is to fit and unloading valve directly off the pump outlet. When unloaded half the flow could pass through the unloading valve and half through the control valve. When the engine speed is reduced to 1000rpm the unloading valve can be closed allowing the reduced flow to pass to the control valve and operate the winch at the correct speed.
When driving pumps using engines especially with fixed displacement pumps you should always consider the working and the maximum rpm of the pump. It might be necessary to adjust the specification to cater for the extra flow.
Attributed to: Omar Khayam, 13th century philosopher
He who knows not, and knows not that he knows not, is a fool. Shun him.
He who knows not, and knows that he knows not, is a child. Teach him.
He who knows, and knows not that he knows, is asleep. Wake him.
He who knows, and knows that he knows, is a leader. Follow him.

Very best
Bob Jackson (The Hydraulic man)

More hydraulics at www.hydraulicbrain.com